If you have lost or damaged your EZ Pilot drone during flight, we offer the drone only replacement part here:



To bind the replacement drone:

1. Start with the Drone and Controller are powered off.

2. Press and hold the throttle trim down and pitch trim down buttons on the Controller while powering the Controller on by holding down the center button. When the green light flashes quickly in the center ring release all buttons. 

3. Bring the Controller and the Drone close together (6-12 inches) and power on the Drone, then the green light in the center of the Controller will turn solid. 

4. Power off the Drone (unplug battery) and Controller (hold down center power button) and then power on again, the bind should be completed.