The calibration/arming issue is due to the gyro calibration and noise floor being set too low. This can be remedied in the CLI tab of Betaflight. You just need to enter "set gyro_calib_noise_limit = 150" and then "save". The value can go up to 200, but that is unlikely to be needed. If raising the noise floor doesn't resolve the issue, please reach out to support.
Gyro Calibration Error - Prevents Arming Print
Modified on: Wed, Dec 18, 2019 at 2:32 PM
Did you find it helpful?Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.