BetaFlight

Betaflight Configurator - Use Correct Version
Each version of the Betaflight Configurator is configured to work with a certain subset of firmware for the flight controller. The Configurator's user ...
Mon, Dec 23, 2019 at 3:44 PM
Drone Does Not Connect
If you are struggling with getting your drone to connect to your computer for Betalfight/BLHeli, make sure that you are using a data USB cable. Some cables ...
Thu, Dec 19, 2019 at 4:54 PM
SPI Receiver D16 Protocol Binding
Changes in Betaflight To bind the drone's built-in SPI receiver (i.e. TinyHawk v2, TinyHawk S, TinyHawk Freestyle) using D16 protocol, you must first ...
Fri, Jan 17, 2020 at 2:17 PM
Gyro Calibration Error - Prevents Arming
The calibration/arming issue is due to the gyro calibration and noise floor being set too low. This can be remedied in the CLI tab of Betaflight. You just n...
Wed, Dec 18, 2019 at 2:32 PM
Flip Over After Crash (Turtle Mode/Crash Flip)
Potential ESC/Motor Damage Please only use crash flip (aka turtle mode, anti turtle mode, flip over after crash) if you are an experienced pilot  know t...
Fri, Mar 27, 2020 at 11:54 AM
E6 (RTF) Radio Transmitter - Arming/Controls/Binding Issues
When using the E6 transmitter (e.g. radio controller from a TinyHawk RTF bundle), you may encounter issues with binding/arming/controlling a BNF drone. To r...
Wed, Feb 19, 2020 at 9:26 AM
Basic Betaflight & FrSky Radio Setup (TinyHawk Series)
For those looking for a good basic guide on Betaflight & FrSky radio setup for the TinyHawk series, check out this video: https://youtu.be/Sz8pgZ6y5XA
Mon, Feb 17, 2020 at 9:00 AM
BetaFlight Configurator - Installing Multiple Versions
QUESTION/ISSUE Is there a way to install multiple instances of BetaFlight Configurator on your PC?  I've got a TinyHawk (which needs v10.4.0), a Ti...
Wed, Feb 19, 2020 at 10:48 AM
Drone is Drifting in a Certain Direction
FPV drones do not hold hovering position like a GPS camera drone. But if it is drifting a lot, first make sure all of your transmitter trims are center...
Mon, Mar 30, 2020 at 2:29 PM